|
Who's Online
There currently are 5961 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Good service manual,i saved from scrapping this deck,is now fully functional.Thanks.
;
Found this to be the manual included with the original packinging, was helpfull but did not give any detailed repair instructions.
;
Complete service manual, was very helpful in repairing this tapedeck.Thanks.
;
The service manual was a copy of the original from Wirlpool. The quality was good, all neccecary information was available including the service-codenumbers, so I could order the right part to be replaced for repair.
Downloding was no probem after the payment.
Thanks for the service!
;
Good,readable manual. I found other manuals that were not readable when it came to part ID, but the one downloaded from owner-manual.com was better than expected. I will do buisness with owner-manual.com again.
AL-1250
3. AE level adjustment (OC mode)
[Input method] When the PHOTO lamp lights up, press and hold the density select key for 5 sec, and the AUTO mode lamp will blink and the adjusted level will be displayed on the exposure level display. [Adjustment] For adjustment, press the density adjustment key too select the density in 5 steps. [Terminating method] Press the density select key, and the model display will turn from blinking to lighting to terminate the AE level adjustment.
4. AE level adjustment (SPF mode)
[Input method] While the SPF mode lamp is lighting, when the PHOTO mode lamp lights up, press and hold the density select key for 5 sec, and the AUTO mode lamp will blink and the adjusted level will be displayed on the exposure level display. [Adjustment] For adjustment, press the density adjustment key to select the density in 5 steps. [Terminating method] When the density select key is pressed, the mode display will turn from blinking to lighting to terminate the AE level adjustment.
5. Toner save mode setup and cancel
[Input method] When the TEST mode lamp lights up, press and hold the density select key for 5 sec, and the PHOTO mode lamp will turn from blinking to lighting and the adjusted level will be displayed on the exposure level display. [Setup/Cancel] Press the left key: Level �1� ON, toner save mode setup Press the right key: Level �5� ON, toner save mode cancel. [Terminating method] When the density select key is pressed, the mode display turns from blinking to lighting to terminate setup.
8-2
$4.99 AL-1250 SHARP Parts Catalog Parts Catalog only. It's available in PDF format. Useful, if Your equipment is broken and You need t…
|
|
|
> |
|